I have a question? I hear many on here say they use 2 tanks.1 filled with SH the other water and then use a manifold,ball valve or whatever to control the mix going out.Then switching to straight water to clean out your system.
If you are doing this when & where are you adding your surfactants,TSP, Dawn or whatever else you decide to put in your mix??
I am currently keeping 1 tank SH & the other as my mixing tank that I draw from, just mixing what I need for each project.
Then when done I just fill up some buckets & run about 20 gallons of clean water through the system.
I am setting up my new truck this week and I need all the direction I can get. Any help or thoughts would be greatly apreciated
-- Edited by aaron61 on Sunday 27th of March 2011 09:38:07 AM
I have a question? I hear many on here say they use 2 tanks.1 filled with SH the other water and then use a manifold,ball valve or whatever to control the mix going out.Then switching to straight water to clean out your system.
If you are doing this when & where are you adding your surfactants,TSP, Dawn or whatever else you decide to put in your mix??
I am currently keeping 1 tank SH & the other as my mixing tank that I draw from, just mixing what I need for each project.
Then when done I just fill up some buckets & run about 20 gallons of clean water through the system.
I am setting up my new truck this week and I need all the direction I can get. Any help or thoughts would be greatly apreciated
-- Edited by aaron61 on Sunday 27th of March 2011 09:38:07 AM
Good idea, start a thread in the preium section and I'll show you my two tank setup.
-- Edited by Apple Roof Cleaning Tampa FL (813) 655-8777 on Sunday 27th of March 2011 10:36:04 AM
Hey Aaron, simply add a "T fitting" to the inlet of your pump,..from the two remaining inlets from the "T" add ball valves and hoses,..and simply run the hoses to the tanks. Switch as needed.